WinBook 32mo User Manual
12. The LCD panel used in this product is made of glass. Therefore, it can break if the product is
dropped or struck.
13. During the LCD panel lifespan it is normal for a few pixels to become defective. Non-active
pixels may appear on the screen as fixed points of red, blue or green. Refer pixel policy
questions to the reseller for further clarification on acceptable loss.
questions to the reseller for further clarification on acceptable loss.
14. An outside antenna system should not be located in the vicinity of overhead power lines or
other electrical conduits. When installing an outside antenna, use extreme caution to prevent
the antenna from coming into contact with said items, as contact with them may be fatal.
the antenna from coming into contact with said items, as contact with them may be fatal.
15. Outdoor antenna grounding:
If an outside antenna is connected to the LCD TV, be sure the antenna system is grounded so
as to provide some protection against voltage surges and built-up static charges. Article 810
of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper
grounding of the mast and supporting structure, ground of the lead-in wire to antenna
discharge unit, size of grounding conductors, location of antenna-discharge unit, connection
to grounding electrodes, and requirements for the grounding electrode.
as to provide some protection against voltage surges and built-up static charges. Article 810
of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper
grounding of the mast and supporting structure, ground of the lead-in wire to antenna
discharge unit, size of grounding conductors, location of antenna-discharge unit, connection
to grounding electrodes, and requirements for the grounding electrode.
Antenna Lead in Wire
Ground Clamp
Antenna Discharge Unit
(NEC SECTION 810-20)
(NEC SECTION 810-20)
Grounding Conductors
(NEC SECTION 810-21)
(NEC SECTION 810-21)
Electric Service
Equipment
Ground Clamps
Power Service
Grounding Electrode
System (NEC ART 250,
PART H)
Grounding Electrode
System (NEC ART 250,
PART H)
NEC – National Electrical Code