Sony CDX-C8050X Manual

The following items can be set:

•Clock (page 10)
•Beep - to turn on or off the beeps.
•RM (Rotary Commander) - to change the

operative direction of the controls of the
rotary commander.
— Select “norm” to use the rotary

commander as the factory-set position.

— Select “rev” when you mount the rotary

commander on the right side of the
steering column.

•Multi language (language selection) - to

change the display language to English,
French, or Spanish.

•D.Info (Dual Information) - to display the

clock and the play mode at the same time (on)
or to display the information alternately (off).

•SA (Spectrum Analyzer) - to change the

display pattern of the equalizer display.

•Dimmer - to change the brightness of the

display.
— Select “Auto” to dim the display only

when you turn the lights on.

— Select “on” to dim the display.
— Select “off” to deactivate Dimmer.

•Contrast - to adjust the contrast if the

indications in the display are not
recognisable because of the unit’s installed
position.

•M.Dspl (Motion display) - to turn the motion

display to 1, 2 , or off.

•A.Scrl (Auto Scroll) (page 13)

•EQ Tune (Equalizer tuning) - to adjust the

frequency and volume level of the equalizer
curve.

•Front HPF (High pass filter for the front pre-

output) - to select the cut-off frequency of the
front pre-output.

•Rear HPF (High pass filter for the rear pre-

output) - to select the cut-off frequency of the
rear pre-output.

•SUB LPF (Low pass filter for the subwoofer

output) - to select the cut-off frequency of the
subwoofer output.

Press (MENU).

Press either side of (DISC/PRST)
repeatedly until the desired item
appears.
Each time you press (–) side of
(DISC/PRST), the item changes as follows:
Example:

Clock t Beep t RM t Multi language t

D.Info t SA t Dimmer t Contrast t

M.Dspl t A.Scrl t Local t Mono t IF t

EQ Tune t Front HPF t Rear HPF t SUB LPF

t Name edit t NameDel t BTM

Tip
You can easily switch among categories (“SET”,
“DIS”, “P/M”, “SND” and “EDT”) by pressing
and holding either side of (DISC/PRST) for two
seconds.

Press either side of (SEEK/AMS) to select
the desired setting (Example: “on” or
“off”).

Press (ENTER).
After the mode setting is complete, the
display returns to normal playback mode.