Trendnet tv-ip422 Installation Instruction
15. Disconnect the RJ-45 cable and
unplug the power. Then plug the
power back in (TV-IP422W).
power back in (TV-IP422W).
English
7
14. Click Site Survey. Select your
wireless network. If encryption
is enabled, select the proper
Authentication type, enter the
Pre-Shared Key and then click
apply. (Example shows
WPA2-PSK. If your wireless
network does not support WPA,
select open or shared instead.
Contact your network
administrator for more
information) (TV-IP422W only).
is enabled, select the proper
Authentication type, enter the
Pre-Shared Key and then click
apply. (Example shows
WPA2-PSK. If your wireless
network does not support WPA,
select open or shared instead.
Contact your network
administrator for more
information) (TV-IP422W only).
16. Verify the Power and Link LEDs
are on.
Note: The TV-IP422W will not work wirelessly until you disconnect the Ethernet
cable from the back of the camera.
cable from the back of the camera.
13. Click Setup, Network and then
click Wireless.
(TV-IP422W only).