3com 8807 Reference Guide

C

HAPTER

 66: NQA C

ONFIGURATION

 C

OMMANDS

■

When probing, the system sends one packet every time. While the test process 
is not always so.

■

One test may include many probes. The test succeeds as long as there is one 
successful probe.

■

The current "probe failure times" will be reset to zero after a test is finished, 
that is, the "times" is only valid for a single test and can not cross two tests for 
constant statistics. If the probe succeeds, this statistic value is reset to zero too.

Related command: test-failtimes.

# Set that the system sends Trap information after 3 times constant probe failures 
in an NQA test.

<SW8800>system-view

 

System View: return to User View with Ctrl+Z.

 

[SW8800] nqa-agent enable

 

[SW8800] nqa administrator icmp

 

[3Com-administrator-icmp] probe-failtimes 3 

NQA test group view

None

Use the sendpacket passroute command to assume the connection mode 
between the destination address and the equipment which enables the test as 
direct connection mode. So called direct connection mode is that the connection 
between the destination address and the equipment enabling the test is not 
through the Layer 3 data exchange equipment.

Use the undo sendpacket passroute command to cancel this assumption.

By default, no such assumption

n 

■

If you assume the connection mode to the destination address as direct 
connection mode, actually it equals to set the TTL to 1.

■

If you assume the connection mode as direct mode, but set the TTL value at the 
same time, then the TTL value does not take effect. This value takes effect 
when you cancel the configuration on the connection mode.