3com 8807 Reference Guide

Ethernet port view

None

Use the shutdown command to disable the Ethernet port.

Use the undo shutdown command to enable the Ethernet port.

By default, the Ethernet port is enabled.

# Enable Ethernet port Ethernet2/1/1.

<SW8800> system-view

 

System View: return to User View with Ctrl+Z.

 

[SW8800] interface Ethernet2/1/1

 

[3Com-Ethernet2/1/1] undo shutdown 

speed { 10 | 100 | 1000 | 10000 | auto }

Ethernet port view

10: Speed on the port is 10 Mbps.

100: Speed on the port is 100 Mbps.

1000: Speed on the port is 1000 Mbps.

10000: Speed on the port is 10 Gbps.

auto: Port speed is in peer auto-negotiation status.

Use the speed command to configure the port speed.

Use the undo speed command to restore the default speed.

The optional parameters of this command are determined by the port types and 
duplex modes. For example, the 10/100/1000 Mbps electrical ports support three 
optional parameters including 10 Mbps, 100 Mbps, and 1000 Mbps. You can 
select proper port speed as you require. But when the duplex mode is changed 
into half duplex mode, the port speed can be set to 1000 Mbps or auto.