3com 8807 User Guide

You can use the following commands to specify Ethernet ports for a VLAN.

Perform the following configuration in VLAN view.

By default, the system adds all the ports to a default VLAN whose ID is 1.

Note that you can add/remove the trunk and Hybrid ports to/from a VLAN by the 
port/undo port commands in Ethernet port view, but not in VLAN view.

The following sections describe the protocol-based VLAN configuration tasks:

■

■

You can use the following commands to create/delete a VLAN protocol type.

Perform the following configuration in VLAN view.

Perform the following configuration in Ethernet port view.

n 

■

The port to be associated with a protocol-based VLAN must be of Hybrid type 
and in this VLAN.

■

The same protocol can be configured in the different VLANs, but cannot be 
configured repeatedly in the same VLAN.

■

A port cannot be associated with different VLANs with the same protocols 
configured.

Table 38   Specify Ethernet ports for a VLAN

Add Ethernet ports to a VLAN 

port interface-list 

Remove Ethernet ports from a VLAN 

undo port interface-list

Table 39   Create/Delete a VLAN protocol type

Create a VLAN protocol type 

protocol-vlan [ protocol-index ] { at | ipx { 
ethernetii | llc | raw | snap } | mode { 
ethernetii etype etype-id | llc dsap dsap-id 
ssap ssap-id | snap etype etype-id } } 

Delete an existing VLAN protocol type 

undo protocol-vlan { protocol-index [ to 
protocol-end ] | all }

Table 40   Associate/Dissociate a port with/from a protocol-based VLAN

Associate a port with a protocol-based VLAN 

port hybrid protocol-vlan vlan vlan-id { 
vlan-protocol-list | all } 

Remove a port from a protocol-based VLAN 

undo port hybrid protocol-vlan vlan { 
vlan-id { vlan-protocol-list | all } | all }