Lexmark Optra T Installation Instruction
18
Install Memory and Optional Cards
6
Align the connection points on the card with
the connector on the system board and push
them firmly into the system board connector.
the connector on the system board and push
them firmly into the system board connector.
7
Insert the two screws saved from the metal
plate (or the extra screws shipped with the
card) into the holes as shown.
plate (or the extra screws shipped with the
card) into the holes as shown.
8
Tighten the screws to secure the card.
Reattach Shield and Close Doors
After you have installed card(s) on the printer sys-
tem board, follow these steps to reattach the shield
and close the doors.
tem board, follow these steps to reattach the shield
and close the doors.
1
Grasp the shield by the tabs and align the
three keyholes on the shield with the top
three screws. Holding the shield by the tabs,
slide it down. Tighten all six screws.
three keyholes on the shield with the top
three screws. Holding the shield by the tabs,
slide it down. Tighten all six screws.
2
Close the side door.
3
Close the upper and lower front doors.
Note: If you have not completed the section
Tabs