Bunn CWT APS-DV User Guide

Page 20

FIG.10 START SWITCH

P1417

Location:

The start switch is located on the front of the hood

in the center of switch panel.

Test Procedure:
1. Disconnect the brewer from the power supply.
2. Disconnect the blue wire from the top switch

terminal and the white/red wire from the bottom
switch terminal.

3. Check for continuity across the two terminals on

the switch when it is held in the lower position.
Continuity must not be present across these ter-
minals in the upper position.

If continuity is present as described, reconnect the
blue wire to the top terminal and the white/red wire to
the bottom terminal. The switch is operating properly.
If continuity is not present as described, replace the
switch.

FIG. 11 START SWITCH TERMINALS

P1133

36102 090203

Removal and Replacement:
1. Remove the blue wire and white/red wire from the

start switch.

2. Turn off the water supply and remove faucet.
3. Remove front end cap.
4. Compress the clips inside the hood and gently

push the switch through the opening.

5. Push new switch into the opening and spread the

clips to hold the start switch in the hood.

6. Reinstall front end cap.
7. Reinstall faucet and reconnect the brewer to the

water supply.

8. Refer to Fig. 11 when reconnecting the wires.

BLU from Timer

WHI/RED to ON/OFF
Switch