Bunn FMD-1 User Guide

24

J1

FIG. 15 DISPENSE SWITCH TERMINALS

P1449

BLK

RED

LEFT

RIGHT

BLK

RED/WHI

BLK

RED

       ORN

BLU/WHI

     ORN

BLK/WHI

FMD-1

FMD-2

FIG. 16  FAN

Location:
 

The fan is located inside the dispenser housing 

on the right rear of the dispenser base plate.

Test Procedures:

1.  Disconnect the dispenser from the power source.

2.  Disconnect the black and white wires from the fan 

terminals.

3.  Check the voltage across the black and white wires 

on the main harness with a voltmeter. Connect the 

dispenser to the power source. The indication must 

be:

 

a) 120 volts ac for two wire 120 volt models.

 

b)  120  volts  ac  for  three  wire  120/208  volt  or 

120/240 volt models.

 

c) 230 volts ac for two wire 230 volt models.

If voltage is present as described, replace the fan

If voltage is not present as described, refer to wiring 

diagram and check the dispenser wiring harness.

Removal and Replacement:

1.  Disconnect the vacuum hose from the fan.

2.  Remove the two #8-32 locking screws securing the 

fan to the dispenser housing base plate.

3.  Disconnect the wires from the fan terminals and 

discard the fan

4.   Refer to Fig. 17 and connect the wires to the new 

fan.

5.  Install new fan through the rear access hole and 

secure to the dispenser housing base plate using 

two #8-32 locking screws.

6.  Reconnect the vacuum hose to the fan.

P1665

BLK from Control Harness

WHI from Control Harness

FIG. 17 FAN TERMINALS

P1507

29112 091307