Bunn ITCB User Guide

Page 10

36748 101505

1.  Begin each brew cycle with a clean empty brew funnel and server.  (Be sure the server lid doesn’t interfere 

with the flow of dilution water.)

2.  Insert a BUNN filter into the funnel.

3.  Pour the packet of loose fresh tea leaves into the filter.  Approximately three to five ounces is recommended 

for three gallons of beverage.

4.  Level the bed of tea leaves by gently shaking.

5.  Slide the funnel into the funnel rails until it stops.

6.  The ON/OFF must be ON.  Select which batch size to brew.

7.  Momentarily press and release the assigned BREW button.  There may be certain situations in which the 

brew cycle will not begin when BREW is pressed:

 

a. 

SWITCH NOT ON - ON/OFF must be ON.

b.  BREW TEMPERATURE TOO LOW – wait until heated or cancel BREW LOCKOUT option (Page 17).

 

c.  CHECK FUNNEL – remove funnel, empty previously brewed leaves and replace with fresh tea leaves.

 

d. 

DISABLED - select different brew button or batch size.

8.  If none of the above messages are displayed, the display will read NOW BREWING and show the time re-

maining in the brew cycle.

9.  Following the brew will be a countdown of drip time DRIPPING which shows the time remaining until the 

tea no longer drips from the funnel tip.

10.  Carefully remove the brew funnel and discard the tea leaves and filter only after visible dripping stops.

1.  Begin each brew cycle with a clean empty brew funnel.

2.  Insert a BUNN filter into the funnel.

3.  Pour the fresh coffee into the filter and level the bed of grounds by gently shaking.

4.  Slide the funnel into the funnel rails until it stops.

5.  Place an empty server under the funnel.

6.  The ON/OFF must be ON. Select the FULL batch size.

7.  Momentarily press and release the assigned BREW button. There may be certain situations in which the brew 

cycle will not begin when BREW is pressed:

 

a. 

SWITCH NOT ON - ON/OFF must be ON.

b.  BREW TEMPERATURE TOO LOW – wait until heated or cancel BREW LOCKOUT option (Page 17).

c.  CHECK FUNNEL – remove funnel, empty previously brewed grounds and replace with fresh.

 

d.  DISABLED - select different brew button or batch size. 

 

e.  COFFEE FUNNEL? – appears when brew volume is greater than 86.0 oz. (2.54 L) and pulse brew is 

disabled. Check to make sure the correct funnel is in place, and then press BREW again.

8.  If none of the above messages are displayed, the display will read NOW BREWING and show the time remain-

ing in the brew cycle.

9.  Following the brew will be a countdown of drip time DRIPPING which shows the time remaining until the 

coffee no longer drips from the funnel tip.

10. Carefully remove the brew funnel and discard the grounds and filter only after visible dripping stops.

1.  Select the small batch size on the grinder. 

2.  Insert a BUNN filter into the funnel.

3.  Grind the selected amount of fresh coffee into the Smart Funnel using the G9-2T DBC or MHG with Smart 

Funnel operation and level the grounds by gently shaking.

4.  Slide the funnel into the funnel rails. The brewer will read the coffee name and size ground through the chip 

in the funnel handle.