TROY Group 3005 User Guide

S 

Security Printing Solutions User’s Guide -- 50-70410-002 Rev. A

 

A-5

 

 

The TROY IRD 9050 1

UP

 printer is capable of printing 1-up forward IRD size forms, 1-up return IRD size forms, 

as well as standard size forms.  However, forms other than 1-up IRD forward and return size forms cannot be 
duplexed.  The IRD duplexer in the IRD 9050 1

UP

 printer is only compatible with 1-up forward and return IRDs.  

All other forms must be printed in simplex mode.  When printing using simplex mode, the TROY IRD 9050 1

UP

 

printer does not route forms through the duplexer, so the 1-up IRD form restriction imposed by the IRD duplexer 
path does not apply when using simplex printing.  To print standard-size forms, the 100-sheet multipurpose tray 
must be installed on the printer. 

 

The TROY IRD 9050 1

UP

 printer can be reconfigured to duplex standard size forms by replacing the IRD 

duplexer with the standard HP duplexer designed for the HP 9050 printer and is available as an accessory from 
TROY.  The TROY IRD 9050 1

UP

 printer does not support duplexing of both 1-up IRD and standard forms 

without changing the duplexer.  In addition, the TROY IRD 9050 1

UP

 printer must be configured to match the 

type of paper loaded in each of the paper trays. 

 

For paper trays containing standard forms, the printer should be configured with settings that exactly match the 
forms.  Only the special 1-up IRD forms require adjusted dimensions as discussed on page A-1.  The 1-up IRD 
paper trays supplied standard with the IRD 9050 1

UP

 printers cannot be used for standard form sizes.  To print 

standard-size forms in the TROY IRD 9050 1

UP

 printer, the IRD paper trays must be substitutes with standard 

paper trays, available as accessories from TROY. 

 

The TROY IRD 9050 1

UP

 printer supports two IRD/standard 500-sheet paper trays plus an optional 2,000-sheet 

“high capacity” paper tray.  These three trays can be mixed between IRD paper trays and standard HP paper trays 
in any combination to meet your printing requirements.  However, the host application must be configured to 
command the printer to only print standard form sizes in simplex mode in order to avoid the standard-size forms 
from being routed through the IRD duplexer.  Any attempt to print standard-size forms in duplex mode with the 
IRD duplexer installed will result in the form jamming in the duplexer section of the printer. 

 

It is important to note that commanding the TROY IRD 9050 1

UP

 printer to print in simplex mode is entirely 

different than commanding it to print in duplex mode without any printing on the second side of the form.  When 
printing in simplex mode, the TROY IRD 9050 1

UP

 printer routes the form past the imaging section of the printer 

only once and then directly to the output bin.  The form does not pass through the duplexer section. 

 

When printing in duplex mode, even if no printing will appear on the second side of the form, the TROY IRD 
9050 1

UP

 printer routes the form past the imaging section, through the duplexer, and back past the imaging 

section a second time before routing the form to the output bin.  Therefore, standard-size forms cannot be printed 
in duplex mode with the IRD duplexer installed even if no printing is to appear on the back side of the form.