Cma -180uc Quick Setup Guide

Connect hard wire power supply from dishmachine 

to power box. (Two hot wires, one neutral and one 

ground.)

Level dishmachine by adjusting leveling legs. 

Dishmachine must be level front and back. 

Connect dishmachine to hot water source, minimum 

temperature 140

∞. If 140∞ is not available, order a  3 

minute timer cycle (120

∞ minimum temperature 

required).

When ever possible, 

remove pump drain if a floor

drain is available near by. Remove drain pipe and

place drain hose on the drain valve and allow

machine to gravity drain.

3-2007

180UC 

Quick Setup 

Instructions

180UC REAR VIEW

Connect the drain hose to wall or floor drain. The 

floor drain must have a 1 inch air gap between

drain hose and floor drain.

: Electrical and

plumbing connections need
to be made by a qualified
service person who will
comply with all available
Federal, State and Local
Health, Electrical,
Plumbing and Safety
codes.

Adjust pressure regulator located behind side panel,
to 20 psi (maximum).

Turn power switch to "ON" position. Hold down 
"FILL" switch until water overflows into the scrap
drawer.

After filling dishwasher for the first time, 

(CAUTION: 

turn power supply off) reconnect the factory 
unplugged wire to booster high-limit switch located
behind front panel.

180UC FRONT VIEW

Chemical dispenser electrical hookup is located
inside control box. Chemical dispenser is optional.
It is not sold with dishmachine.

3-2007

180UC 

Quick Setup 

Instructions

: Electrical and

plumbing connections need
to be made by a qualified
service person who will
comply with all available
Federal, State and Local
Health, Electrical, Plumbing
and Safety codes.