Epson CX6400 Quick Reference Card
1
Insert the paper support into the slots behind the printer, as shown.
2
Lower the feeder guard into the slots behind the scanner lid.
(Insert the hinges on the feeder guard into the corresponding
slots on the printer.)
(Insert the hinges on the feeder guard into the corresponding
slots on the printer.)
EPSON Stylus
®
CX6400
Start Here
1
Wait until you see “Initial Charge” displayed on the control panel.
2
Lift up the scanner section.
3
Shake the package of ink cartridges four or five times.
Then remove the cartridges from the package.
Then remove the cartridges from the package.
Caution: You must install all cartridges and leave them installed
for all types of printing. To avoid damaging the Stylus CX, never
move the print head by hand.
for all types of printing. To avoid damaging the Stylus CX, never
move the print head by hand.
4
Open the cartridge cover.
5
Place each cartridge in its holder.
6
Press down on each cartridge until it clicks into place.
Install Ink Cartridges
4
1
Extend the output tray.
2
Slide the edge guide to the left.
3
Place a stack of paper against the right side of the feeder,
but don’t push it in. Slide the edge guide against the paper.
but don’t push it in. Slide the edge guide against the paper.
7
Close the ink cartridge cover, then close the scanner section.
The Stylus CX begins charging the ink delivery system.
Charging takes about 2 minutes. The green light flashes and the
Stylus CX makes various sounds. Don’t turn it off while the green
light is flashing or you’ll waste ink.
Stylus CX makes various sounds. Don’t turn it off while the green
light is flashing or you’ll waste ink.
1
Make sure you have all the parts shown here. If any parts are missing,
contact EPSON
contact EPSON
®
as described on the back of this sheet.
2
Remove all blue packing tape from the printer.
3
Lift up the scanner section. If it doesn’t open, make sure you have
removed all the tape.
removed all the tape.
4
Peel off the tape from the ink cartridge holder.
5
Close the scanner section.
Unpack
Turn over
1
5
Load Paper
Attach the Parts
2
1
Plug the Stylus CX into a grounded electrical outlet.
Caution: Do not connect the USB cable until instructed.
2
Press and hold the On button until the green lights come on.
Plug In and Turn On
3
Paper support
Software
CD-ROM
CD-ROM
Quick Reference
EPSON Stylus CX6400
Ink cartridges
Feeder guard
Don’t touch the green part
CPD-16930R1 4049040-00 XXX
On button
continue