Epson rx510 Installation Guide

Cautions and Notes

Cautions must be observed to avoid damage to your
equipment.

Notes contain important information and useful tips on the
operation of this product.

Unpacking

Make sure the following parts are included and not damaged.

Removing Protect

Material

Pick up the protective material and install it in the secure position
following the Notice Sheet. Make sure the protective material
around the ink cartridges are removed.

Unlocking

Open the document cover and slide the transportation lock lever.

Setup

4047356-00
XXX

power cord

paper support

ink
cartridges

The contents may vary in certain locations.
The power cord comes attached in some countries.

CD-ROM

feeder guard

film holder

Attaching the Parts

1. Attach the paper support.

2. Connect the document cover’s cable to the TPU interface

connector.

Turning On

Plug in the power cord and press the P On button to turn on this
product.

Note:
Do not connect this product to your computer before step

or you will fail to install the software.

Installing Ink Cartridges

1. Open the scanner unit.

Press

2. Open the cartridge cover.

3. Remove an ink cartridge from its package.

4. Place each cartridge into its holder. Then, push the ink cartridge

down until it clicks into place and close the cartridge cover.

Note:
Install all ink cartridges. This product does not work unless all
cartridges are installed properly.

5. Lower the scanner unit.

Ink charging starts and it takes about two minutes to complete.

Initial charge...

appears on the LCD panel and this product

produces a variety of mechanical sounds. This is normal.

Caution:
❏ Never turn off this product during the ink charging process.

❏ Do not load paper until ink charging is complete.

Selecting a Language

1. Press the Setup button and

A button until 6.Languages
appears on the LCD panel
and then press the x Color
button.

2. Select a language by

pressing the D button.

3. Press the OK button.

Menu items appear in the
selected language.

Do not touch

Loading Paper

1. Open the output tray.

2. Move the feeder guard towards you.

3. While holding down its locking tab, slide out the edge guide.

4. Load the stack of paper with the printable side facing up and

resting against the guide of feeder guard.

5. Stand the stack of paper against the paper support.

6. Move the feeder guard back.

Now you are ready to use this product as a stand-alone device.
See the next section to learn how to make a test copy. If you want
to install software, see “Connecting to Your Computer” on the
reverse side of this sheet.

Making Copies

1. Place a document on the document table.

2. Press the Copy Mode button to enter the Copy Mode.

guide