Epson R320 Quick Reference Card

Unpack

Remove everything from the box.

Remove all the tape and
packing material from
the printer.

Open the output tray and the printer cover.
Then remove the tape.

Make sure the CD/DVD tray guide
is closed completely.

Turn On the Printer

Unwrap the ink cartridges.

Open the cartridge cover and remove the paper insert.

Lower each cartridge into its holder with the green circuit board facing the front.

The color of the cartridge label should match the marker above the cartridge holder.

Then gently push each ink cartridge down until it is firmly seated.

Close the cartridge cover.

Press the

Maintenance button and close the printer cover.

CAUTION: Don’t turn off the printer or interrupt charging while the light is flashing or
you’ll waste ink.

A progress bar is displayed on the LCD panel during ink charging.

After ink charging is finished, press

OK.

Plug the printer’s power cord into a grounded electrical outlet.

STOP: Do not connect the printer to your computer yet. Wait until you are instructed
to connect the USB cable in section 5, “Install Software.”

Press the

Power button to turn on the printer.

CAUTION: Never use an external switch, such as a wall switch or power strip switch,
to turn the printer on or off.

CD position

check paper

Small CD

insert

Printer

Printer Basics

Printer Software

CD-ROM

CD/DVD tray

Quick Reference

Ink cartridges

Turn over

Make sure the tray guide is

up after removing the tape

Flip open the paper support and pull up the extension.

Open the printer cover.

Install the
Ink Cartridges

Don’t touch the green circuit
board or remove any labels

continue

Epson Stylus Photo R320

CPD-18377
4050614-00
XXX

Epson Stylus

Photo R320

Start
Here