BG 210i User Guide
© BG Corp 2005
14
Base Assembly Instructions for 520i / 420i
Loudspeaker
5. Attach the metal stand as shown in the picture by holding the wooden
base and the metal stand together (Fig.2). Tighten the screws at the
bottom and place the loudspeaker vertically.
NOTE: If you have a hard surfaced floor, the sharp pointed spikes may
scratch the surface when the loudspeaker is set vertically on its feet. Four
protective metal disks are included with your loudspeaker for placement
under the spikes. The disks are small therefore it is recommended you
use a larger protective device, such as stiff plastic or cardboard, that can-
not be pierced while positioning your loudspeakers. Replace the protec-
tive device with the metal discs after you have finalized placement of the
loudspeakers. Make sure the center of the spike fits directly into the cen-
tral stabilizing dent located in the center of the metal disc.
protective metal disks are included with your loudspeaker for placement
under the spikes. The disks are small therefore it is recommended you
use a larger protective device, such as stiff plastic or cardboard, that can-
not be pierced while positioning your loudspeakers. Replace the protec-
tive device with the metal discs after you have finalized placement of the
loudspeakers. Make sure the center of the spike fits directly into the cen-
tral stabilizing dent located in the center of the metal disc.
Fig. 2 Attaching the base and the metal stand.
Special Assembly Instructions