Heartland 3800 User Manual

Page of 32
9
Clearances
• Minimum distance between the cooktop and a side wall above the cooktop surface is 6”
(see dim "J" in Table 2 on next page)
• 0” Clearance to the back of the cooktop may be obtained when installing the appliance against a non - combustible wall or
with the installation of our Splashback Kit. Responsibility for ensuring that the rear wall is non - combustible lies with the
owner or end user. (check local building codes) - if wall behind cooktop is deemed combustible and our splashback kit is
not installed, then the minimum spacing from the back of stove to nearest combustible wall is 6”
• Depth of cutout must not exceed 25”.  (see dimension G) Air intake slots on underside of control panel must not  be
obstructed 
or covered.
Electrical requirements:
• Electrical hookup must be done by a licenced electrician
• 120 Volts 60Hz .375 kW   3 prong plug  5 ft-(1.5 m)  power cord included.
Gas Requirements:
• Gas hook-up must be done by a licensed gas fitter.
• Pressure requirements: Natural gas: 6” W.C. (min);  LP gas: 11” W.C. (min)
• Connection: 1/2” NPT
• An accessible manual shut off valve must be installed at the appliance.
• Note: This unit contains a pre-set regulator.
• Natural Gas/Propane Conversion kits are available - must be done by a licensed gas fitter
Figure 1
Dim
36" Metro Cooktop
A
26 5/8" (68cm)
B
8 1/4" (21cm)
C
36" (91cm)
D
1
Standard profile:12 3/4" (32 cm)
(as shown in diagram)
D
2
 low profile: 10 1/8" (26 cm)
D
3
 high back w/ shelf:
28 1/4" (72cm)
Table 1
B
C
Installation Diagram- 36” Metro CooktopModel  3825
Air intake slots on underside
of control panel must not be
obstructed or covered.