Speco ht-intt5 User Guide
9
10
When you call Camera Address
01
01
->Push 0 Button
->Push 1 Button
->Push CAM Button
Power Connector
(DC12V in)
(DC12V in)
485(+),(-)
Baud Rate Setting
Buzzer On/Off
Operating your camera ( Option )
1. When controlled by RS-485, Pelco-D protocol (Option), refer to the following.
A. DIP Switch Setting on the Camera
(Factory default : Camera Address = 01, Baud Rate = 2400bps)
B. Receiver Setting to use with IR Remote Controller
(Factory default : Baud Rate = 2400bps, Chart is same as
above)
above)
C. System Integration
D. IR Remote Controller ( Optional )
- Can call and control each camera on the monitor by the following.
Multiflexer
CCD Camera
Monitor
SET button
UP button
DOWN
button
button
RIGHT button
LEFT button
Receiver
IR Remote
Controller
485(+)
485(-)
①
②
•Please Observe Polarity!
•Up to 15 Cameras can be
controlled by 1 IR Remote
Controller & 1 Receiver. You
must set up each camera’s
address by DIP Switches for
proper addressing.
controlled by 1 IR Remote
Controller & 1 Receiver. You
must set up each camera’s
address by DIP Switches for
proper addressing.