eMachines t4060 Supplementary Manual
T4060 BIOS Flash
After downloading the self-extracting BIOS flash utility and the BIOS flash instructions
from the drivers section of the web site, follow the instructions below to flash your
system BIOS.
WARNING ! Interrupting, or powering off your system during the flashing process
could permanently damage your system.
1. Insert a blank floppy disk into the floppy disk drive, and click the OK button.
NOTE: If there are any files on this disk, they will be erased.
2. The files will now be extracted to the floppy disk in drive A:
3. When the extraction process has completed, leave the floppy in the floppy drive,
3. When the extraction process has completed, leave the floppy in the floppy drive,
and restart the system.
4.
A short flash utility will take place
5. When complete, you will see on the screen the DOS A> prompt.
6. At this point remove the floppy disk from the floppy drive, and restart the
6. At this point remove the floppy disk from the floppy drive, and restart the
system.
7. After you restart the system you will see a message on the screen that
states “CMOS Checksum Error - Defaults Loaded” “Press F1 to continue
or DEL to enter Setup”
or DEL to enter Setup”
8. At this point press the <F1> key to continue.
9. The system will then boot into Windows XP and you have now completed
9. The system will then boot into Windows XP and you have now completed
the BIOS update process.