LG LWC0960AHG Owner's Manual

11

1. To avoid vibration and noise, make sure the unit is installed securely and firmly.
2. Install the unit where the sunlight does not shine directly on the unit. 

If the unit receives direct sunlight, build an awning to shade the cabinet.

3. There should be no obstacle, like a fence, within 50cm which might restrict heat radiation from the

condenser.

4. Install the unit a little obliquely outward not to leak the condensed water into the room (about

10mm)

5. Install the unit with its bottom portion 70-150cm above the floor level.
6. The power cord must be connected to an independent circuit. The green wire must be grounded.
7. Connect the drain tube to the base pan hole.

Plastic hose or equivalent may be connected to the drain tube.

Before installing the Air Conditioner back into the case, remove the white styrofoam shipping block
from the compressor.

70~150cm

BASE PAN

DRAIN TUBE

COOLED AIR

AWNING

HEAT RADIATION

ABOUT 10mm

OVER 50cm

FENCE

Remove white
styrofoam block.

If a power plug is not to be used, provide a circuit breaker between power source and the unit as
shown below.

Main power source

Circuit Breaker
Use a circuit breaker or time
delay fuse.