APC 125KVA PDU w/ 480 PRI 208/120 SEC K 1 XMER PD125G6FK1 User Manual
Product codes
PD125G6FK1
Section 1: General Information
6
SPDU Technical Handbook
Floor jacks.
A set of (four per unit) floor jacks (p/n PDFJ100) can optionally be applied to the
SPDU (and each of its attached sidecars) to provide leveling and/or additional clearance for bottom
cable feed. The jacks are offered in heights of up to 18 inches, and are adjustable from one to three
inches above the base.
Full-frame floor stand.
A full-frame floor stand (p/n PDFS100 for 75-225[K13] kVA units, and p/
n PDFS130 for the 225[K20] unit and all 300 kVA units) can optionally be applied to the SPDU (and
each of its attached sidecars) to provide leveling and bottom cable access independent of a raised
floor. The floor stand is constructed of welded steel, and is offered in heights of up to 32 inches with
an adjustment range of +/- 3 inches.
Seismic bracing.
Seismic bracing (p/n PDSB100) is optionally available as a means of securing the
base frame of the SPDU (and each of its attached sidecars) to a concrete floor for those installations
where additional stability is either required or desired.
Custom engineering.
APC has allocated ample resources for the expressed purpose of responding
to requests for custom engineered solutions. A “custom engineered” design involves the use of
assemblies and/or components outside the realm of the company’s standard offerings. Such non-
standard assemblies and components are typically specified by the customer as a means of satisfying
requirements relating to performance, flexibility, durability, cost, or even personal preference.
Note
A condition of APC’s custom engineering process is the ability to SAFELY and
FEASIBLY incorporate changes into a new or existing product design.