LG 65UH650V User Guide

9

t Antenna Isolator Installation Guide (Depending on model)

 

- Use this to install TV in a place where there is a voltage 

difference between TV Set and GND of antenna signal.

 

» If there is a voltage difference between TV Set and GND of 

antenna signal, the antenna contact might be heated and 
excessive heat might cause an accident.

 

- You can improve the safety when watching TV by efficiently 

removing power voltage from TV antenna. It is recommended 
to mount the isolator to the wall. If it cannot be mounted to 
the wall, mount it on the TV. Avoid disconnecting the antenna 
Isolator after installation.

 

- Before starting, be sure that the TV antenna is connected.

ANTENNA/

CABLE IN

Wall

Cable / 
Antenna

or

Isolator

1. Connect to TV.

2. Connect to Set-Top box.

Connect one end of the isolator to cable/antenna jack and the other to 
TV set or set-top box.

“Equipment connected to the protective earthing of the building 
installation through the mains connection or through other equipment 
with a connection to protective earthing - and to a cable distribution 
system using coaxial cable, may in some circumstances create a fire 
hazard. Connection to a cable distribution system has therefore to be 
provided through a device providing electrical isolation below a certain 
frequency range (galvanic isolator, see EN 60728-11)”

 When applying the RF Isolator, a slight loss of signal sensitivity can 
occur.

t Do not use any unapproved items to ensure the safety and product 

life span.

t Any damage or injuries caused by using unapproved items are not 

covered by the warranty.

t Some models have a thin film attached on to the screen and this 

must not be removed.

t When attaching the stand to the TV set, place the screen facing 

down on a cushioned table or flat surface to protect the screen 
from scratches.

t Make sure that the screws are inserted correctly and fastened 

securely. (If they are not fastened securely enough, the TV may tilt 
forward after being installed.) Do not use too much force and over 
tighten the screws; otherwise screw may be damaged and not 
tighten correctly.

t Make sure to wring any excess water or cleaner from the cloth.
t Do not spray water or cleaner directly onto the TV screen.
t Make sure to spray just enough of water or cleaner onto a dry cloth 

to wipe the screen.

t When cleaning the product, be careful not to allow any liquid or 

foreign objects to enter the gap between the upper, left or right 
side of the panel and the guide panel. (Depending on model)

Separate purchase items can be changed or modified for quality 
improvement without any notification. Contact your dealer to buy these 
items. These devices only work with certain models.
The model name or design may be changed depending on the upgrade 
of product functions, manufacturer’s circumstances or policies.

(Depending on model)

AG-F***
Cinema 3D Glasses

AN-MR650
Magic Remote

AN-VC550
Smart camera

AG-F***DP
Dual Play Glasses