LG 42LV555H Owner's Manual

15

206-4200

Typical Installer Menu

Use the Installer Menu to set up, change, or view operational settings.

Refer to the table starting on the next page for brief descriptions of Installer Menu items. 

More detailed descriptions follow the table listing.

1.  Make sure the TV is ON. 
2.  Using an Installer Remote, press 

MENU repeatedly until the on-

screen display of the TV setup menus (if the TV is in Pass-through 

Mode) or the Function Menu (if the TV is not in Pass-through Mode) 

no longer toggles, and then press 

9-8-7-6 + ENTER to access the 

Installer Menu. 

The Installer Menu opens with item 000 INSTALLER SEQ 000.  
Note: If the password is not entered or registered correctly, you will see 

the message “ENTER PASSWORD 0000” at the top of the screen instead 

of the Installer Menu header. Once you re-enter the correct password 

(i.e., press 

9-8-7-6 + ENTER), the Installer Menu will display.

Note: If the TV is in FTG Mode, the Installer Menu is accessible as read-

only. Refer to pages 33 to 43 for information on FTG Mode configuration.

Refer to the table on pages 16 and 17 for an overview of the available Installer Menu items, including 

their item numbers, functions, value ranges, and default values.
Installer Menu items not relevant to this TV series are not present in the Installer Menu; therefore, 

some numbers are missing. For example, item 006 will not appear. In addition, items that are  

dependent on other Installer Menu item settings will not be initially accessible. For example, item 046 

STRT AUX SRCE will not display in the Installer Menu unless item 004 STRT CHANNEL is set to 0.

Use the Up/Down arrow keys on the Installer Remote to sequence through the available menu items, 

or access an item directly by keying in the item number and then pressing 

MENU. For example, to 

access the SLEEP TIMER option, which is item 015, press 0-1-5 + MENU. 

To change an Installer Menu item value, use the Left/Right arrow keys on the Installer Remote, or 

enter a valid value directly. To save the new setting, press 

ENTER, or use the Up/Down arrow keys 

to navigate to a new Installer Menu item if you have additional items to edit. Note that invalid values 

will not be saved.

After you have adjusted all required Installer Menu item settings, press 

ENTER once on the Installer 

Remote to save your changes; then, press 

ENTER again to exit the Installer Menu. Any changes you 

make will be stored in non-volatile memory. 
Note: Each time you exit the Installer Menu in Pass-through Mode, all V-Chip (Parental Control) 

settings in the TV are reset to their default values; that is, the Lock System, if previously enabled 

from the Lock setup menu (see the Owner’s Manual for additional information), will now be disabled, 

and the individual Parental Control settings will be restored to default values.