LG Video Wall Owner's Manual

Picture ID is used to change the settings of a 

specific display using a single IR receiver for 

multi-vision. The set receiving the IR signal 

communicates with another set via an RS232 

connection. Each set is identified by a Set ID. If 

you assign the Picture ID using the remote control, 

only displays with the same Picture ID and Set ID 

can be controlled remotely.

1

  Press the red ON button on the remote control 

to assign the Picture ID.

2

  If you press the left/right buttons or press the 

ON button repeatedly, the Picture ID cycles 
through OFF and 1 to 4. Assign the ID you 
want.

 

y

If you assign the Set ID to each set with 

multi-vision, and then assign the Picture ID 

using the red button on the remote control, 

the key command is displayed for the set 

with the same Set ID and Picture ID. A set 

with different Set IDs and Picture IDs cannot 

be controlled by IR signals.

 

y

For more information on how to assign the 

 

y

The maximum value of the Picture ID can be 

set in the Total Set ID menu.

 

y

Please refer to the Installation Manual for 

more information on Total Set ID assignment.

 

y

For example, if the Picture ID is assigned 
to 2, the upper right display (Set ID: 2) can 
be controlled by IR signals.

 

y

For each set, you can change the 
settings for the PICTURE, AUDIO, TIME, 
NETWORK and MY MEDIA menus or the 
hot keys on the remote control.

 

y

 If you press the green OFF button for 
Picture IDs, the Picture IDs for all sets are 
turned off. If you then press any button 
on the remote control, all sets will start 
working again.

 

y

Picture ID will be disabled while using the 
MY MEDIA menu.

Picture ID

Close

◀        

Off

        ▶

2X2 Multi-Vision (Total Set ID: 4)

Set IDs are assigned as shown in the picture.

IR Receiver

Picture ID

Close

◄           Off           ►