LG BH9540TW Owner's Manual

14

C

onnecting

1.  Insert the Wireless TX till the marked line into 

the WIRELESS connector on the rear of the unit.

Line

2.  Connect the power cord of the wireless receiver 

to the outlet.

3.  When you turn on the main unit, the wireless 

speakers connection will be completed 
automatically.

 

- When the connection is completed, you can 

see the yellow-green LED on the wireless 
receiver and the indicator ( ) on the main 
unit.

Yellow-green 
(Blink)

The wireless receiver is trying to 
connect.

Yellow-green

The connection is completed.

Red

The wireless receiver is 
in standby mode or the 
connection is failed.

Off  
(No display)

The power cord of wireless 
receiver is disconnected.

 

y Do not insert other than the Wireless TX 

dedicated for this unit into the WIRELESS 
connector. This unit might be damaged or it 
may not be removed easily.

 

y If there is a strong electromagnetic wave 

product nearby, interference may occur. Put 
the unit (wireless receiver and main unit) 
away from there. 

 

y It takes a few seconds (and may take longer) 

for the Wireless TX and the wireless receiver 
to communicate with each other.

 

y The available range is 20 m for wireless 

connection in an open place.

 

,

When your connection is not completed, you can 

see the red LED or the blinking yellow-green LED 

on the wireless receiver and the rear speakers are 

not made sound. To solve the problem, follow the 

below steps.
1.  Adjust the volume level of the main unit to 

minimum. 

 

- ”VOL MIN” appears on the display window.

2.  Press and hold  (MUTE) on the remote control 

for about 3 seconds.

 

- “WL RESET” appears on the display window 

briefly.

3.  If the LED of the wireless receiver already blinks 

in yellow-green continually, you can skip this 

step.

 

Press and hold PAIRING on the rear of the 

wireless receiver for more than 5 seconds.

 

- The LED of the wireless receiver lights up 

alternately in red and yellow-green.

4.  Disconnect the power cord of the main unit 

and the wireless receiver.

5.  Connect them again after the LED of the main 

unit and the wireless receiver are fully turned 

off. 

 

The main unit and the wireless receiver will 

be paired automatically when you turn on the 

main unit.

 

- When the connection is completed, you can 

see the yellow-green LED on the wireless 

receiver and the indicator ( ) on the main 

unit.