KitchenAid 1200 CFM in-line blower Installation Guide

Gather the required tools and parts before starting installation. 
Read and follow the instructions provided with any tools listed 
here.

■

Drill

■

1¼" (3 cm) drill bit

■

³⁄₁₆" (0.5 cm) drill bit

■

Pencil

■

Wire stripper or utility knife

■

Tape measure or ruler

■

Pliers

■

Caulking gun and weatherproof caulking compound

■

Vent clamps

■

Jigsaw or keyhole saw

■

Flat-blade screwdriver

■

Metal snips

■

Phillips screwdriver

■

½" (1.3 cm) UL listed or CSA approved wiring conduit and 
connectors

■

6 - 18 AWG wires, one each of the following colors: black, 
white, red, blue, gray, and green or green/yellow (ground)

NOTE: The length of the conduit and 18 AWG wires is 
determined by the distance between the in-line blower motor 
and range hood terminal boxes.

■

11 - UL listed wire connectors

■

½" (1.3 cm) UL listed or CSA approved strain relief

Remove parts from packages. Check that all parts are included.

■

4 - 6.3 x 60 mm mounting screws

■

4 - flat washers

■

6-wire connector assembly for range hood

■

2 - strain relief connectors

■

1 - strain relief bushing

IMPORTANT: Observe all governing codes and ordinances.

Have a qualified technician install the in-line blower motor 
system.  

All openings in the ceiling and wall where the in-line blower motor 
system will be installed must be sealed.

The installation of this in-line blower motor system must conform 
to the Manufactured Home Construction Safety Standards, Title 
24 CFR, Part 328 (formerly the Federal Standard for Mobile Home 
Construction and Safety, Title 24, HUD, Part 280) or when such 
standard is not applicable, the standard for Manufactured Home 
Installation 1982 (Manufactured Home Sites, Communities and 
Setups) ANSI A225.1/NFPA 501A*, or latest edition, or with local 
codes.