KitchenAid 30'' Slow Cook Warming Drawer Dimensional Illustrations

KOWT100E

KOWT104E

KOWT107E

IMPORTANT: Observe all governing codes and ordinances.
•  Cutout dimensions that are shown must be used. Given dimensions 

provide minimum clearance with warming drawer.

•  Recessed installation area must provide complete enclosure around 

the recessed portion of the warming drawer.

•  Grounded electrical supply is required. See “Electrical Requirements” 

section.

•  Electrical supply outlet should be located in the rear wall on the upper 

right-hand side of the cutout or in an adjacent cabinet. The outlet 

must be recessed. If the electrical outlet is located in an adjacent 

cabinet, a 1³⁄

8

" (3.5 cm) minimum diameter hole should have been 

drilled in the back of the cutout or support surface to pass the power 

supply cord through to the outlet.

•  Warming drawer support surface must be solid, level and flush with 

bottom of cabinet cutout.

•  Warming drawers with oiled bronze, black glass, and white glass 

panels are approved for indoor use only.

For best performance results make sure the warming drawer is leveled 

before completing installation. There is no way to level the warming 

drawer after it has been installed. If the installation is not level, the door 

may slide open or not seal tightly, allowing heat to escape.

24" 

(61 cm)

23¹⁄

8

" 

(58.7 cm)

22¹⁄

4

" 

(56.5 cm)

9" (22.9 cm)

23³⁄

4

" 

(60.3 cm)

10¹⁄

4

" 

(26.1 cm)

27" 

(68.6 cm)

23¹⁄

8

" 

(58.7 cm)

25¹⁄

4

" 

(64.1 cm)

9" (22.9 cm)

26³⁄

4

" 

(67.9 cm)

10¹⁄

4

" 

(26.1 cm)

30" 

(76.2 cm)

23¹⁄

8

" 

(58.7 cm)

28¹⁄

4

" 

(71.8 cm)

9" (22.9 cm)

29³⁄

4

" 

(75.6 cm)

10¹⁄

4

" 

(26.1 cm)

Because Whirlpool Corporation includes a continues commitment to improve 

our products, we reserve the right to change materials and specifications 
without notice.

Dimensions are for planning purposes only. For complete details, 

see Installation Instructions packed with product. Specifications 
subject to change without notice.

Ref. W10713339A

03/15

A 120 volt, 60 Hz., AC only, 15-amp fused, electrical circuit is required. 

A time-delay fuse or circuit breaker is also recommended. It is 

recommended that a separate circuit serving only this warming drawer 

be provided.

24" 

(61 cm)

2¹⁄

2

" 

(6.4 cm)

9¹⁄

8

" 

(23.2 cm)

1" (2.5 cm)/  

4¹⁄

4

" (10.8 cm)

22¹⁄

2

" 

(57.1 cm)

24" 

(61 cm)

27" 

(68.6 cm)

2¹⁄

2

" 

(6.4 cm)

9¹⁄

8

" 

(23.2 cm)

1" (2.5 cm)/ 

4¹⁄

4

" (10.8 cm)

25¹⁄

2

" 

(64.8 cm)

27" 

(68.6 cm)

30" 

(76.2 cm)

2¹⁄

2

" 

(6.4 cm)

9¹⁄

8

" 

(23.2 cm)

1" (2.5 cm)/ 

4¹⁄

4

" (10.8 cm)

28¹⁄

2

" 

(72.4 cm)

30" 

(76.2 cm)

Warming drawer can be installed as an indoor single or double 

installation or installed under a single oven. Two warming drawers 

under a single oven are shown.

NOTE: The warming drawer cannot be leveled after being installed.
For outdoor installation follow the cutout dimensions above. Install the 

outdoor warming drawer in a permanent fixture.

Custom Wood Drawer Front
If you plan to install a custom wood panel to match your cabinets, we 

recommend consulting a qualified cabinetmaker or carpenter. The back 

of the wood panel must be sealed to avoid moisture damage.

Page 1 of 2