KitchenAid 27" Combination Wall Oven with Even-Heat™ True Convection (lower oven) Installation Guide
7
1. Connect the 2 black wires (C) together using a UL Listed wire
connector.
2. Connect the 2 white wires (D) and the green (or bare) ground
wire (of the oven cable) using a UL Listed wire connector.
3. Connect the 2 red wires (G) together using a UL Listed wire
connector.
4. Install junction box cover.
Install Oven
1. Using 2 or more people, lift oven partially into cabinet cutout.
Use the oven opening as an area to grip.
NOTE: Push against seal area of oven front frame when
NOTE: Push against seal area of oven front frame when
pushing oven into cabinet. Do not push against outside edges.
2. Push against the seal area of the front frame to push the
oven into the cabinet until the back surface of the front frame
touches the front wall of the cabinet.
3. Push oven completely into cabinet and center oven into
cabinet cutout.
4. Remove the tape from black front trims.
■
Securely fasten the oven to the cabinet using the #8-14 x
¾" screws provided.
■
Insert the screws through hole in black trim aligning
with hole in oven frame. Do not overtighten screws.
A
B
C
A. Oven frame
B. Oven frame hole
C. Black trim piece
B. Oven frame hole
C. Black trim piece
5. The bottom vent is shipped in the foam packing at the top
of the oven. Install the bottom vent (C) as follows:
■
Align vent tab (B) with oven frame (A) as shown.
■
Using one #8-18 x
3
/
8
" screw (D) on each side of the vent
tab (B), fasten the vent securely to the oven.
6. Replace oven racks.
7. Replace the oven door. See the “Replace Oven Door(s)”
7. Replace the oven door. See the “Replace Oven Door(s)”
section.
8. Check that door is free to open and close. If it is not, repeat
the removal and installation procedures. See the “Prepare
Built-In Microwave/Oven Combination” section.
9. Reconnect power.
10. The display panel will light briefly, and “PF” should appear in
10. The display panel will light briefly, and “PF” should appear in
the display.
11. If the display panel does not light, please reference the
“Warranty” section of the Use and Care Guide.
Install Warming Drawer Deflector Kit
(Only for Ovens Installed Above Warming
Drawers)
On combo microwave/oven models installed above a warming
drawer, a warming drawer deflector kit must be installed. See
the “Tools and Parts” section for ordering information.
Parts Supplied
A
B
D
C
A. Oven frame
B. Vent tab
B. Vent tab
C. Bottom vent
D. #8-18 x
D. #8-18 x
3
/
8
" screws
B
A
A. Phillips head screws (4)
only 2 screws for 27" (68.6 cm) size
B. Warming drawer deflector (1)