KitchenAid 30-Inch 5 Burner Gas Double Oven Convection Range Installation Guide

3.  Determine and mark edge of range in the cutout space. The 

mounting bracket can be installed on either the left side or 

right side of the cutout. Position mounting bracket in cutout 

so that right (or left) edge of the bracket is 

15

/

16

" (2.4 cm) from 

the marked edge of the range, as shown.

4.  Drill two 

1

/

8

" (3.0 mm) holes that correspond to the bracket 

holes of the determined mounting method. See the following 

illustrations.

5.  Using a Phillips screwdriver, mount anti-tip bracket to the 

wall or floor with the two #12 x 1

5

/

8

" screws provided.

1.  Apply pipe-joint compound made for use with LP gas to the 

smaller thread ends of the flexible connector adapters (see B 

and G in the following illustration).

2.  Attach one adapter to the gas pressure regulator and 

the other adapter to the gas shut-off valve. Tighten both 

adapters being certain not to move or turn the gas pressure 

regulator.

3.  Use a 

15

/

16

" combination wrench and an adjustable wrench to 

attach the flexible connector to the adapters.
IMPORTANT: All connections must be wrench-tightened. Do 

not make connections to the gas pressure regulator too tight. 

Making the connections too tight may crack the regulator 

and cause a gas leak. Do not allow the regulator to turn 

when tightening the fittings.