KitchenAid 27" Combination Wall Oven with Even-Heat™ True Convection (lower oven) Installation Instruction

Page of 16
7
Install Oven
1. Using 2 or more people, lift the oven partially into the cabinet 
cutout. Use the oven opening as an area to grip.
NOTE: When pushing the microwave oven into the cabinet, 
open the microwave oven door and push against the seal 
area on the front frame. Do not push against the outside 
edges.
2. Push against the front frame of the microwave oven to push 
oven into cabinet.
3. Push the microwave oven completely into the cabinet and 
center the microwave oven into the cabinet cutout.
4. Remove the tape from the black front trim piece.
Securely fasten the oven to the cabinet using the #8-14 x 
³⁄₄" screws provided.
Insert the screws through the hole in the black trim piece, 
aligning with the hole in the oven frame. Do not 
overtighten the screws.
Install Deflector Kit Bracket
This assembly is required for use when a single or double built-in 
oven is installed in a flush installation.
1. Flex the upper vent piece (C) away from the lower vent piece 
(D) to slide the deflector bracket (B) between them. Some 
force may be required to flex the upper vent trim (C) away 
from the lower vent trim (D). Some force may also be required 
to flex the deflector bracket (B) and slide it into position. 
Make sure screw holes are properly aligned between the two 
pieces. See the following illustration.
2. Install the deflector bracket (B) to the lower vent piece (D) 
using two #8-18 x 
¹⁄₄" screws on each side.
NOTE: On 27" (68.6 cm) models, only one #8-18 x 
¹⁄₄" screw 
is used on each side.
3. Align vent tab (B) with oven frame (A) as shown.
4. Using one #8-18 x 
³⁄₈" screw (E) on each side of the vent tab 
(B), fasten the vent securely to the oven.
5. Replace the oven racks.
6. Replace the oven door. See the “Replace Oven Door(s)” 
section.
7. Check that the door is free to open and close. If it is not, 
repeat the removal and installation procedures. See the 
“Prepare Built-In Oven” section.
A. Oven Frame
B. Oven frame hole
C. Black trim piece
A
B
C
A. #8-18 x 
¹⁄₄
" screws
B. Deflector bracket
C. Upper vent piece (supplied with oven)
D. Lower vent piece (supplied with oven)
A. Oven frame
B. Vent tab
C. Oven vent
D. Deflector bracket
E. #8-18 x 
³⁄₈
" screw
D
B
A
C
B
D
C
A
C
D
B
E