Netgear M4300-28G (GSM4328S) - Stackable Managed Switch with 24x1G and 4x10G including 2x10GBASE-T and 2xSFP+ Layer 3 Software Guide

To display a route map, use the show route-map command in Privileged EXEC mode.

(NETGEAR Switch) # show route-map test

route-map test, permit, sequence 10

     Match clauses:

       ip address prefix-lists: orange

     Set clauses:

       set metric 50

This section describes the commands you use to view and configure Router Discovery 
Protocol settings on the switch. The Router Discovery Protocol enables a host to discover the 
IP address of routers on the subnet.

This command enables Router Discovery on an interface or range of interfaces. 

Interface

The interface.

Route-map

The route map 

Format

show route-map [map-name] 

Mode

Privileged EXEC

map-name

(Optional) Name of a specific route map.

Default

disabled

Format

ip irdp 

Mode

Interface Config