Netgear M5300-52G-POE+ (GSM7252PSv1h2) - ProSAFE 48+4 L2+ POE Stackable Managed Switch Software Guide
Manage Device Security
616
M6100, M5300, and M7100 Series Managed Switches
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
do not enter a password.
6.
Click the Login button.
The web management interface menu displays.
7.
Select Security > Control > DHCP Snooping > Interface Configuration.
8.
Use the Interface check boxes to select the interface.
9.
If Trust Mode is enabled, DHCP snooping application considers the port as trusted.
The factory default is Disable.
10.
If Invalid Packets is enabled, DHCP snooping application logs invalid packets on this
interface.
The factory default is Disable.
11.
Use Rate Limit (pps) to specify rate limit value for DHCP snooping purposes.
If the incoming rate of DHCP packets exceeds the value of this for consecutive burst
interval seconds, the port is shut down. If this value is N/A, then burst interval has no
meaning, hence it is disabled. The default value is N/A. It can be set to value –1, which
means N/A. The range of rate limit is 0 to 300.
interval seconds, the port is shut down. If this value is N/A, then burst interval has no
meaning, hence it is disabled. The default value is N/A. It can be set to value –1, which
means N/A. The range of rate limit is 0 to 300.
12.
Use Burst Interval (secs) to specify the burst interval value for rate limiting purpose on this
interface.
If the rate limit is N/A, burst interval has no meaning and it is N/A. The default value is
N/A. It can be set to –1, which means N/A. The range of Burst Interval is 1 to 15.
N/A. It can be set to –1, which means N/A. The range of Burst Interval is 1 to 15.
Configure DHCP Snooping Binding
To configure snooping binding:
1.
Prepare your computer with a static IP address in the 169.254.100.0 subnet, for
example, 169.254.100.201.
2.
Connect an Ethernet cable from an Ethernet port on your computer to an Ethernet port on
the switch.