Netgear M4300-52G-PoE+ (GSM4352PB) - 48x1G PoE+ Stackable Managed Switch with 2x10GBASE-T and 2xSFP+ (1,000W PSU) Software Guide
Switching Commands
476
M4200 and M4300 Series ProSAFE Managed Switches
Link Dependency Commands
Link dependency allows the link status of specified ports to be dependent on the link status of
one port or many ports. Consequently, if a port on which other ports depend loses a link, the
dependent ports either become administratively disabled and are brought down or become
administratively enabled and are brought up.
one port or many ports. Consequently, if a port on which other ports depend loses a link, the
dependent ports either become administratively disabled and are brought down or become
administratively enabled and are brought up.
link state group
Use this command to indicate if the downstream interfaces of a specified group must mirror
or invert the status of the upstream interfaces. The default configuration for a group is down.
That is, the downstream interfaces mirror the upstream link status by going down when all
upstream interfaces are down. Specifying the up keyword allows the downstream interfaces
to come up when all upstream interfaces are down.
or invert the status of the upstream interfaces. The default configuration for a group is down.
That is, the downstream interfaces mirror the upstream link status by going down when all
upstream interfaces are down. Specifying the up keyword allows the downstream interfaces
to come up when all upstream interfaces are down.
link state group downstream
Use this command to add a group of interfaces to the downstream interface list. Adding an
interface to a downstream list brings the interface down until an upstream interface is added
to the group. The link status then follows the interface that is specified in the link state
group upstream
interface to a downstream list brings the interface down until an upstream interface is added
to the group. The link status then follows the interface that is specified in the link state
group upstream
command. To prevent interfaces from being brought down, enter the
link state group upstream
command before you enter the link state group
downstream
command.
no link state group downstream
Use this command to remove a group of interfaces from the downstream list.
Default
down
Format
link state group group-id action {up | down}
Mode
Global Config
Format
link state group group-id downstream
Mode
Interface Config
Format
no link state group group-id downstream
Mode
Interface Config