Netgear M4300-12X12F (XSM4324S) - Stackable Managed Switch with 24x10G including 12x10GBASE-T and 12xSFP+ Layer 3 Software Guide
Use the Auto Install Configuration
26
M4200 and M4300 Series ProSAFE Managed Switches Software Setup Manual
Configure Auto Install
The following figure shows an Auto Install configuration with a DHCP server and a TFTP
server, allowing a configuration file to be distributed across a chassis.
server, allowing a configuration file to be distributed across a chassis.
The following information is configured on the DHCP server:
•
The IP address (yiaddr) and subnet mask (option1)
•
The name of the configuration file (bootfile or option 67)
•
The IP address of the TFTP server (option 150)
The configuration file is located on the TFTP server (for example, switch.cfg).
Figure 1. Components in an Auto Install configuration
Configure Auto Install Through the CLI
This section describes how to configure Auto Install through the CLI.
To use the CLI to configure Auto Install:
1.
Download the configuration file from the TFTP server.
2.
Save the configuration file automatically after autoconfig completes.
(Netgear switch) #boot host auto-save
3.
Continue Auto Install:
(Netgear switch) #boot autoinstall start
192.168.0.1
192.168.0.2
192.168.0.3
DHCP
server
server
TFTP
server
server