Netgear GS752TXS - Stackable Smart Gigabit Ethernet Switch User Manual

 

To configure port settings:

To configure settings for a physical port, click PORTS.

To configure settings for a Link Aggregation Group (LAG), click LAGS. 

To configure settings for both physical ports and LAGs, click ALL.

Select the check box next to the port or LAG to configure. You can select multiple ports and 

LAGs to apply the same setting to the selected interfaces. Select the check box in the 

heading row to apply the same settings to all interfaces.

Configure or view the settings:

. Enter the description string to be attached to a port. The string can be 

up to 64 characters in length.

For most ports this field is blank. Otherwise, the possible values are:

MON: Indicates that the port is a monitoring port. For additional information about 

port monitoring, see 

268.

LAG: Indicates that the port is a member of a Link Aggregation trunk. For more 

information, see 

92.

. Use the menu to select the port control administration state, which can 

be one of the following:

Enable: The port can participate in the network (default). 

Disable: The port is administratively down and does not participate in the network.

. Use the menu to select the port’s speed and duplex mode. If you select 

Auto, the duplex mode and speed will be set by the auto-negotiation process. The 
port’s maximum capability (full duplex and 1000 Mbps) will be advertised. Otherwise, 
your selection will determine the port’s duplex mode and transmission rate. The 
factory default is Auto.

. Indicates the physical port’s speed and duplex mode

. Indicates whether the Link is up or down.