Netgear M5300-28G3 (GSM7328Sv2h2) - ProSAFE 24+4 Gigabit Ethernet L3 Managed Stackable Switch Administrator's Guide
Port Routing
108
Managed Switches
b. Scroll down and select the interface 1/0/5 check box.
Now 1/0/5 appears in the Interface field at the top.
c. Enter the following information:
•
In the IP Address field, enter 192.150.5.1.
•
In the Subnet Mask field, enter 255.255.255.0.
•
In the Routing Mode field, select Enable.
d. Click Apply to save the settings.
Add a Default Route
When IP routing takes place on a switch, a routing table is needed for the switch to forward
the packet based on the destination IP address. The route entry in the routing table can either
be created dynamically through routing protocols like RIP and OSPF, or be manually created
by the network administrator. The route created manually is called the static or default route.
the packet based on the destination IP address. The route entry in the routing table can either
be created dynamically through routing protocols like RIP and OSPF, or be manually created
by the network administrator. The route created manually is called the static or default route.
A default route is used for forwarding the packet when the switch cannot find a match in the
routing table for an IP packet. The following example shows how to create a default route.
CLI: Add a Default Route
(FSM7338S) (Config) #ip route default?
<nexthopip> Enter the IP Address of the next router.
(FSM7328S) (Config)#ip route default 10.10.10.2
Note:
IP subnet 10.10.10.0 should be configured using either port routing
(
(
(see
118).