Netgear M5300-28G (GSM7228S) - ProSAFE 24-port Gigabit L2+ Managed Stackable Switch Software Guide
IP Multicast Commands
1122
M5300, M6100, and M7100 Series ProSAFE Managed Switches
PIM Commands
This section describes the commands you use to configure Protocol Independent Multicast
-Dense Mode (PIM-DM) and Protocol Independent Multicast - Sparse Mode (PIM-SM).
PIM-DM and PIM-SM are multicast routing protocols that provides scalable inter-domain
multicast routing across the Internet, independent of the mechanisms provided by any
particular unicast routing protocol. Only one PIM mode can be operational at a time.
-Dense Mode (PIM-DM) and Protocol Independent Multicast - Sparse Mode (PIM-SM).
PIM-DM and PIM-SM are multicast routing protocols that provides scalable inter-domain
multicast routing across the Internet, independent of the mechanisms provided by any
particular unicast routing protocol. Only one PIM mode can be operational at a time.
ip pim dense
This command administratively enables the PIM Dense mode across the router.
Command example:
(NETGEAR) (Config) #ip pim dense
no ip pim dense
This command administratively disables the PIM Dense mode across the router.
ip pim sparse
This command administratively enables the PIM Sparse mode across the router.
Command example:
(NETGEAR) (Config) #ip pim sparse
Default
disabled
Format
ip pim dense
Mode
Global Config
Format
no ip pim dense
Mode
Global Config
Default
disabled
Format
ip pim sparse
Mode
Global Config