Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Software Guide
Captive Portal Commands
811
M5300, M6100, and M7100 Series ProSAFE Managed Switches
no authentication timeout
This command sets the authentication timeout to the default value.
show captive-portal
This command reports status of the captive portal feature.
show captive-portal status
This command reports status of all captive portal instances in the system.
Default
300
Format
authentication timeout seconds
Mode
Captive Portal Config
Format
no authentication timeout
Mode
Captive Portal Config
Format
show captive-portal
Mode
Privileged EXEC
Term
Description
Administrative
Mode
Shows whether the CP is enabled.
Operational Status
Indicates whether the CP operational status is enabled or disabled.
Disable Reason
If CP is disabled, this field displays the reason, which can be None, Administratively
Disabled, No IPv4 Address, or Routing Enabled, but no IPv4 routing interface.
Disabled, No IPv4 Address, or Routing Enabled, but no IPv4 routing interface.
Captive Portal IP
Address
Shows the IP address that the captive portal feature uses.
Format
show captive-portal status
Mode
Privileged EXEC
Term
Description
Additional HTTP
Port
Displays the port number of the additional HTTP port configured for traffic. A value of 0 indicates that
only port 80 is configured for HTTP traffic.
only port 80 is configured for HTTP traffic.
Additional HTTP
Secure Port
Displays the port number of the additional HTTPS secure port. A value of 0 indicates no additional
port and the default port (443) is used.
port and the default port (443) is used.