Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Software Guide

The Local field displays the local preference.

You can create, configure, and delete tunnels.



Prepare your computer with a static IP address in the 169.254.100.0 subnet, for 

example, 169.254.100.201.

Connect an Ethernet cable from an Ethernet port on your computer to an Ethernet port on 

the switch.

Launch a web browser.

Enter the IP address of the switch in the web browser address field.

The default IP address of the switch is 169.254.100.100. 

The Login screen displays.

Enter the user name and password. 

The default admin user name is admin and the default admin password is blank, that is, 
do not enter a password.

Click the Login button. 

The web management interface menu displays.

Select Routing

> IPv6 > Advanced > Tunnel Configuration. 

In the Tunnel ID field, select from the list of available tunnel IDs.

In the Mode list, select a supported mode:

6-in-4-configured

6-to-4

Select the IPv6 Mode from the list. 

 IPv6 on this interface using the IPv6 address. 

This option is configurable only until you specify an explicit IPv6 address. 

From the IPv6 Unreachables list, select to Enable or Disable.

This specifies the mode of sending ICMPv6 Destination Unreachables on this interface. If 
you select Disable, then this interface does not send ICMPv6 destination unreachables. 
By default IPv6 destination unreachables mode is enabled.

In the IPv6 Address/Prefix Length field, enter a configured IPv6 address for the selected 

interface.