Netgear M4300-48X (XSM4348CS) - Stackable Switches with Full PoE+ Provisioning Software Guide
Power over Ethernet Commands
1065
M4200 and M4300 Series ProSAFE Managed Switches
no poe
Use this command to disable the Power over Ethernet (PoE) functionality on a global basis or
per interface.
per interface.
poe detection
Use this command to configure the detection type on a global basis or per interface. It is used
to configure which types of PDs will be detected and powered by the switch. There are three
options:
to configure which types of PDs will be detected and powered by the switch. There are three
options:
•
ieee
—Detect resistive-type devices (IEEE standard)
•
pre-ieee
—Legacy capacitive detection only (nonstandard)
•
auto
—Perform resistive detection first (IEEE standard) and capacitive detection
(pre-IEEE standard)
no poe detection
Use this command to set the detection mode to the default on a global basis or per interface.
poe high-power
Use this command to switch a port from 802.3af mode to high-power mode. This mode is
used to power up devices that require more power than the current IEEE 802.3af power
(more than 12.95 watts at the PD). There are three options:
used to power up devices that require more power than the current IEEE 802.3af power
(more than 12.95 watts at the PD). There are three options:
•
legacy—
Use this mode if the device can power up (more than 12.95 watts) with higher
current and it cannot identify itself as a Class 4 device.
•
pre-dot3at—
Use this mode if the device cannot identify itself as a Class 4 device and it
does not have LLDP support.
•
dot3at—
Use this mode if the device is a Class 4 device capable of figuring out power.
Format
no poe
Mode
Global Config
Interface Config
Default
auto
Format
poe detection {ieee | pre-ieee | auto}
Mode
Global Config
Interface Config
Format
no poe detection
Mode
Global Config
Interface Config