Netgear M4300-48X (XSM4348CS) - Stackable Switches with Full PoE+ Provisioning Software Guide
Utility Commands
270
M4200 and M4300 Series ProSAFE Managed Switches
ip name server
Use this command to configure the available name servers. Up to eight servers can be
defined in one command or by using multiple commands. The parameter server-addres
defined in one command or by using multiple commands. The parameter server-addres
s
is a valid IPv4 or IPv6 address of the server. The preference of the servers is determined by
the order they were entered.
the order they were entered.
no ip name server
Use this command to remove a name server.
ip name source-interface
Use this command to specify the physical or logical interface to use as the DNS client (IP
name) source interface (source IP address) for the DNS client management application. If
configured, the address of source Interface is used for all DNS communications between the
DNS server and the DNS client. The selected source-interface IP address is used for filling
the IP header of management protocol packets. This allows security devices (firewalls) to
identify the source packets coming from the specific switch. If a source-interface is not
specified, the primary IP address of the originating (outbound) interface is used as the source
address. If the configured interface is down, the DNS client falls back to its default behavior.
name) source interface (source IP address) for the DNS client management application. If
configured, the address of source Interface is used for all DNS communications between the
DNS server and the DNS client. The selected source-interface IP address is used for filling
the IP header of management protocol packets. This allows security devices (firewalls) to
identify the source packets coming from the specific switch. If a source-interface is not
specified, the primary IP address of the originating (outbound) interface is used as the source
address. If the configured interface is down, the DNS client falls back to its default behavior.
no ip name source-interface
Use this command to reset the DNS source interface to the default settings.
ip host
Use this command to define static host name-to-address mapping in the host cache. The
parameter name is host name and ipaddress is the IP address of the host. The host name
can include 1–255 alphanumeric characters, periods, hyphens, underscores, and
non-consecutive spaces. Hostnames that include one or more space must be enclosed in
quotation marks, for example “lab-pc 45”.
parameter name is host name and ipaddress is the IP address of the host. The host name
can include 1–255 alphanumeric characters, periods, hyphens, underscores, and
non-consecutive spaces. Hostnames that include one or more space must be enclosed in
quotation marks, for example “lab-pc 45”.
Format
ip name-server server-address1 [server-address2...server-address8]
Mode
Global Config
Format
no ip name-server [server-address1...server-address8]
Mode
Global Config
Format
ip name source-interface {unit/slot/port | loopback loopback-id | tunnel
tunnel-id | vlan vlan-id}
Mode
Global Config
Format
no ip name source-interface
Mode
Global Config