Netgear M4300-48X (XSM4348CS) - Stackable Switches with Full PoE+ Provisioning Software Guide
Switching Commands
610
M4200 and M4300 Series ProSAFE Managed Switches
ISDP Commands
This section describes the commands you use to configure the industry standard Discovery
Protocol (ISDP).
Protocol (ISDP).
isdp run
This command enables ISDP on the switch.
no isdp run
This command disables ISDP on the switch.
isdp holdtime
This command configures the hold time for ISDP packets that the switch transmits. The hold
time specifies how long a receiving device should store information sent in the ISDP packet
before discarding it. The period is in the range 10–255 seconds.
time specifies how long a receiving device should store information sent in the ISDP packet
before discarding it. The period is in the range 10–255 seconds.
isdp timer
This command sets the period of time between sending new ISDP packets. The period is in
the range 5–254 seconds.
the range 5–254 seconds.
Default
Enabled
Format
isdp run
Mode
Global Config
Format
no isdp run
Mode
Global Config
Default
180 seconds
Format
isdp holdtime seconds
Mode
Global Config
Default
60 seconds
Format
isdp timer seconds
Mode
Global Config