Netgear M4300-48X (XSM4348CS) - Stackable Switches with Full PoE+ Provisioning Software Guide
Get Started
17
M4200 and M4300 Series ProSAFE Managed Switches Software Setup Manual
Your changes are saved in flash memory (permanent storage).
The switch is now ready for web-based management as well as for management through
Telnet and SSH.
Telnet and SSH.
Use a Console Port and the CLI to Set Up the IP Address
Configuration
Configuration
You can manually configure the IP address of the switch through a console port by using the
CLI. The switch provides a mini USB console port and an RJ-45 RS232 console port.
CLI. The switch provides a mini USB console port and an RJ-45 RS232 console port.
To set up the switch IP address configuration through a console port and the CLI:
1.
Connect a computer with a Windows, MAC, or Linux operating system and a terminal
emulation program or a VT100/ANSI terminal and open the appropriate COM port.
emulation program or a VT100/ANSI terminal and open the appropriate COM port.
When the terminal interface initializes, the user login prompt displays.
2.
Enter your user name and password.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
do not enter a password.
3.
Configure the IP address of the switch’s management interface in default management
VLAN 1 by entering the following command:
VLAN 1 by entering the following command:
(management switch) (config) #ip management vlan 1 ipaddress
subnetmask
4.
Configure the IP address of the switch’s gateway by entering the following command:
(management switch) (config) #ip default-gateway gateway-addr
5.
Disable DHCP mode on the switch’s OOB port by entering the following command:
(management switch) #serviceport protocol none
6.
Configure the IP address of the switch’s OOB port (which is also referred to as the
service port) by entering the following command:
service port) by entering the following command:
(management switch) #serviceport ip ipaddress
subnetmask [gateway]
7.
To retain these changes during a reset of the switch, type save at the main menu prompt,
and type y to confirm the changes.
and type y to confirm the changes.
8.
To view the changes and verify the IP address information, enter the following commands:
•
For the management interface: (management switch) #show ip management
•
For the service port: (management switch) #show serviceport
The switch is now ready for web-based management as well as for management through
Telnet and SSH.
Telnet and SSH.