Netgear GSM7248v2 - ProSAFE 48 Port Layer 2 Gigabit L2 Ethernet Switch Administrator's Guide
Chapter 26. PIM
|
375
ProSafe 7000 Managed Switch Release 8.0.3
received by a router on its RPF interface, the state refresh message causes an existing
prune state to be refreshed. State refresh messages are generated periodically by the router
directly attached to the source. There are two versions of PIM-DM. Version 2 does not use
IGMP messages; instead, it uses a message that is encapsulated in IP packets with protocol
number 103. In version 2, the Hello message is introduced in place of the query message.
prune state to be refreshed. State refresh messages are generated periodically by the router
directly attached to the source. There are two versions of PIM-DM. Version 2 does not use
IGMP messages; instead, it uses a message that is encapsulated in IP packets with protocol
number 103. In version 2, the Hello message is introduced in place of the query message.
CLI: Configure PIM-DM
PIM-DM on Switch A
1.
Enable IP routing on the switch.
(Netgear Switch) #configure
(Netgear Switch) (Config)#ip routing
2.
Enable pimdm on the switch.
(Netgear Switch) (Config)#ip pimdm
3.
Enable IP multicast forwarding on the switch.
(Netgear Switch) (Config)#ip multicast
4.
Enable RIP to build the unicast IP routing table.
(Netgear Switch) (Config)#interface 1/0/1
(Netgear Switch) (Interface 1/0/1)#routing
(Netgear Switch) (Interface 1/0/1)#ip address 192.168.2.2 255.255.255.0
(Netgear Switch) (Interface 1/0/1)#ip rip