Netgear GSM7228PS - ProSAFE 28 ports Gigabit Ethernet L2 Managed Stackable Switch with PoE User Manual

This page displays an entry for every active Trap Receiver. To access this page, click 
System 







 Trap Configuration.

To add a host that will receive SNMP traps, enter trap configuration information in the 
available fields described below, and then click Add.

a. Community Name - Enter the community string for the SNMP trap packet to be sent 

to the trap manager. This may be up to 16 characters and is case sensitive.

b. Version - Select the trap version to be used by the receiver from the pull down 

menu:

SNMP v1 - Uses SNMP v1 to send traps to the receiver.

SNMP v2 - Uses SNMP v2 to send traps to the receiver.

c. Protocol - Select the protocol to be used by the receiver from the pull down menu. 

Select the IPv4 if the receiver's address is IPv4 address or IPv6 if the receiver's 
address is IPv6.

d. Address - Enter the IPv4 address in x.x.x.x format or IPv6 address in 

xxxx:xxxx:xxxx:xxxxx:xxxx:xxxx:xxxx:xxxx or a hostname starting with an alphabet to 
receive SNMP traps from this device. Length of address can not exceed 158 
characters.

e. Status - Select the receiver's status from the pull-down menu:

Enable - Send traps to the receiver

Disable - Do not send traps to the receiver.

To modify information about an existing SNMP recipient, select the check box next to the 
recipient, change the desired fields, and then click Apply. Configuration changes take effect 
immediately.

To delete a recipient, select the check box next to the recipient and click Delete.

Click Cancel to cancel the configuration on the screen and reset the data on the screen to 
the latest value of the switch.