Netgear GS110TP – ProSAFE 8-Port Gigabit Smart Switch with PoE and 2 fiber SFP ports Administrator's Guide
64
|
Chapter 2: Configuring System Information
GS108T and GS110TP Smart Switch Software Administration Manual
LLDP-MED Port Settings
Use this page to enable LLDP-MED mode on an interface and configure its properties.
To display this page, click System
LLDP Advanced LLDP-MED Port Settings.
To configure LLDP-MED settings for a port:
1.
From the Port field, select the port to configure.
2.
From the LLDP-MED Status field, enable or disable the LLDP-MED mode for the selected
interface.
3.
From the Notification field, specify whether the port should send a topology change
notification if a device is connected or removed.
4.
From the Transmit Optional TLVs field, specify whether the port should transmit optional type
length values (TLVs) in the LLDP PDU frames. If enabled, the following LLDP-MED TLVs
are transmitted:
•
MED Capabilities
•
Network Policy
•
Location Identification
•
Extended Power via MDI: PSE
•
Extended Power via MDI: PD
•
Inventory
5.
Click Apply to send the updated configuration to the switch. These changes occur
immediately and the configuration will be saved.
6.
Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.