Netgear M4100-50G-POE+ (GSM7248Pv1h1) - 46‐port GE + 4 GE Combo L2 Managed PoE+ Switch Software Guide

Use this command to configure the detection type on a global basis or per interface. It is used 
to configure which types of PDs will be detected and powered by the switch. There are three 
options:

. Detect resistive-type devices (IEEE standard)

. Legacy capacitive detection only (nonstandard)

. Perform resistive detection first (IEEE standard) and capacitive detection 

(pre-IEEE standard)

Global Config

Interface Config

Use this command to set the detection mode to the default on a global basis or per interface.

Global Config

Interface Config

Use this command to switch a port from 802.3af mode to high-power mode. This mode is 
used to power up devices that require more power than the current IEEE 802.3af power 
(more than 12.95 watts at the PD). There are three options:

. Use this mode if the device can power up (more than 12.95 watts) with higher 

current and it cannot identify itself as a Class 4 device.

. Use this mode if the device cannot identify itself as a Class 4 device and it 

does not have LLDP support.

. Use this mode if the device is a Class 4 device capable of figuring out power 

requirements through 2-event classification or LLDP.

Default

auto

Format

poe detection {ieee | pre-ieee | auto} 

Mode

Format

no poe detection

Mode

Default

dot3at

Format

poe high-power {legacy | pre-dot3at | dot3at}

Mode

Interface Config