Netgear M4300-28G (GSM4328S) - Stackable Managed Switch with 24x1G and 4x10G including 2x10GBASE-T and 2xSFP+ Layer 3 User Manual
Maintenance and Troubleshooting
653
M4200 and M4300 Series ProSAFE Managed Switches Web Management User Manual
The System Information page displays.
5.
Select Maintenance > Save Config > Auto Install Configuration.
The Autoinstall State field displays the current status of the Autoinstall process.
6.
From the AutoInstall Mode menu, select the start/stop auto install mode on the switch.
7.
From the AutoInstall Persistent Mode menu, enable or disable the AutoInstall persistent
mode.
8.
From the AutoSave Mode menu, select Enabled or Disabled.
9.
From the AutoInstall Retry Count menu, specify the number of times the unicast TFTP
tries are made for the DHCP specified file before falling back for broadcast TFTP tries.
10.
Click the Apply button.
The configuration changes that you made are saved across a system reboot. All changes
submitted since the previous save or system reboot are retained by the switch.
submitted since the previous save or system reboot are retained by the switch.
Reset the Switch to Its Factory Default Settings
Note:
If you reset the switch to the default configuration, the IP address is
reset to 169.254.100.100, and the DHCP client is enabled. The IP
address of the OOB port is set to 192.168.0.239.
reset to 169.254.100.100, and the DHCP client is enabled. The IP
address of the OOB port is set to 192.168.0.239.
To reset the switch to the factory default settings:
1.
Launch a web browser.
2.
Enter http://<ipaddress> in the web browser address field.
The login window opens.
3.
Enter the user name and password.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
do not enter a password.
4.
Click the Login button.
The System Information page displays.