Netgear M4100-D10-POE (FSM5210Pv1h1) - 8‐port FE + 2 GE Combo L2 Managed PoE Switch Software Guide

This section describes the commands you use to configure the switch to use a Remote 

Authentication Dial-In User Service (RADIUS) server on your network for authentication and 

accounting.

Use this command to enable the switch to accept VLAN assignment by the radius server.

Use this command to disable the switch to accept VLAN assignment by the radius server.

Use this command to enable the RADIUS accounting function.

OSPFv2 Traps

Can be enabled or disabled. The factory default is disabled. Indicates whether OSPF 
traps are sent. If any of the OSPF trap flags are not enabled, the command displays 
disabled

. Otherwise, the command shows all the enabled OSPF traps’ information.

OSPFv3 Traps

Can be enabled or disabled. The factory default is disabled. Indicates whether OSPF 
traps are sent. If any of the OSPFv3 trap flags are not enabled, the command displays 
disabled

. Otherwise, the command shows all the enabled OSPFv3 traps’ information.

PIM Traps

Can be enabled or disabled. The factory default is disabled. Indicates whether PIM traps 
are sent.

Default

disable

Format

authorization network radius

Mode

Global Config

Format

no authorization network radius

Mode

Global Config

Default

disabled

Format

radius accounting mode

Mode

Global Config