KitchenAid 30" Range Hood with the FIT System Use & Care Manual

Gather the required tools and parts before starting 

installation. Read and follow the instructions provided 

with any tools listed here.

Remove parts from package. Check that all parts are included.

 * For information on ordering, see the “Assistance or Service” 

section.

IMPORTANT: Observe all governing codes and ordinances.

 

■

It is the installer’s responsibility to comply with installation 

clearances specified on the model/serial/rating plate. 

The model/serial/rating plate is located inside the range 

hood on the left wall.

 

■

Range hood location should be away from strong draft 

areas, such as windows, doors and strong heating vents.

 

■

Cabinet opening dimensions that are shown must be 

used. Given dimensions provide minimum clearance. 

Consult the cooktop/range manufacturer installation 

instructions before making any cutouts.

 

■

This range hood is recommended for use with cooktops 

with a maximum total rating of 40,000 BTUs or less.

 

■

Grounded electrical outlet is required. See “Electrical 

Requirements” section.

 

■

All openings in ceiling and wall where range hood will 

be installed must be sealed.

 

■

These range hoods are factory set for non-vented 

installations and require charcoal filters. See the 

“Assistance or Service” section for information 

on ordering charcoal filters.

The installation of this range hood must conform to the 

Manufactured Home Construction Safety Standards, Title 

24 CFR, Part 328 (formerly the Federal Standard for Mobile 

Home Construction and Safety, title 24, HUD, Part 280) 

or when such standard is not applicable, the standard for 

Manufactured Home Installation 1982 (Manufactured Home 

Sites, Communities and Setups) ANSI A225.1/NFPA 501A, 

or latest edition, or with local codes.

Flat-blade
screwdriver

Drill with ¹⁄₈" (3 mm), ¹⁄₂" (13 mm), 
and 1¹⁄₄" (3 cm) bits

Wire stripper

#2 Phillips
screwdriver

Pencil

#8-18 x ⁵⁄₈" 
(4.2 x 16 mm)
truss-head screws

#8-18 x 1"
(4.2 x 25 mm) 
flat-head screws

Drywall
anchors

Mounting
brackets

UL Listed/CSA 
Approved 
wire connectors

UL Listed/CSA 
Approved ¹⁄₂" (13 mm) 
strain relief

120V, 75W 
maximum, 
type E26 
incandescent lamp

Charcoal 
filter kit 
Part Number 
W10355450*

Power 
cord kit 
Part Number
W10355452*

Stainless steel
cleaner and 
polish 
Part Number 
31462A*